mateusz@mateusz-Aspire-5738:~$ sudo usb_modeswitch

Usage: usb_modeswitch [<params>] [-c filename]

 -h, --help                    this help
 -e, --version                 print version information and exit
 -v, --default-vendor NUM      vendor ID of original mode (mandatory)
 -p, --default-product NUM     product ID of original mode (mandatory)
 -V, --target-vendor NUM       target mode vendor ID (optional)
 -P, --target-product NUM      target mode product ID (optional)
 -C, --target-class NUM        target mode device class (optional)
 -b, --busnum NUM              system bus number of device (for hard ID)
 -g, --devnum NUM              system device number (for hard ID)
 -m, --message-endpoint NUM    direct the message transfer there (optional)
 -M, --message-content <msg>   message to send (hex number as string)
 -2 <msg>, -3 <msg>            additional messages to send (-n recommended)
 -n, --need-response           read response to the message transfer (CSW)
 -r, --response-endpoint NUM   read response from there (optional)
 -d, --detach-only             detach the active driver, no further action
 -H, --huawei-mode             apply a special procedure
 -S, --sierra-mode             apply a special procedure
 -O, --sony-mode               apply a special procedure
 -G, --gct-mode                apply a special procedure
 -N, --sequans-mode            apply a special procedure
 -A, --mobileaction-mode       apply a special procedure
 -T, --kobil-mode              apply a special procedure
 -L, --cisco-mode              apply a special procedure
 -B, --qisda-mode              apply a special procedure
 -R, --reset-usb               reset the device after all other actions
 -Q, --quiet                   don't show progress or error messages
 -W, --verbose                 print all settings and debug output
 -D, --sysmode                 specific result and syslog message
 -s, --success <seconds>       switching result check with timeout
 -I, --no-inquire              do not get SCSI attributes (default on)

 -c, --config-file <filename>  load long configuration from file

 -t, --stdinput                read long configuration from stdin

 -f, --long-config <text>      get long configuration from string

 -i, --interface NUM           select initial USB interface (default 0)
 -u, --configuration NUM       select USB configuration
 -a, --altsetting NUM          select alternative USB interface setting


 * usb_modeswitch: handle USB devices with multiple modes
 * Version 1.2.3 (C) Josua Dietze 2012
 * Based on libusb0 (0.1.12 and above)

 ! PLEASE REPORT NEW CONFIGURATIONS !